These Tungsten Carbide Grit Edge Professional Hole Saws are a true Professionals Tool

The Gulleted Edge is coated with a Permanently Bonded Tungsten Carbide Grit. The gulleted edge increases cutting pressure and allows the cut material to be removed .They are designed to take serious abuse and will outlast any conventional Holesaw, they can be used in corded or cordless Drills and even SDS Drills and are built and designed to cut both with or without Full Hammer Action. They can even cut in both directions, they have a high heat and abrasion resistance, they are much tougher than bi metal holesaws and they have no teeth to chip or dull like Carbide Tipped Hole Saws.

These Holesaws leave a fine finish and can cut through tough abrasive materials like Brick, Masonry, Slate, Marble, Ceramic Wall Tiles, Construction Materials such as Autoclaved Cement Board, Fibreglass, Composite Boards such as Chipboard and MDF, Laminates, Rubber Tires Tyres, GRP, CFRP, Hardwood Flooring, Laminate Flooring, Plasterboard / Drywall, Soft Resinous Woods and Hard Brittle Materials. For a fuller list see our Material Chart in the main menu.

Blades Can be wire brushed clean to increase lifespan

Check our Material Chart for Fuller list of what this Amazing Tool will cut through

Videos of Products in Action

Many of the applications that these saw blades are used for would bind and load up, or wear out the teeth on traditional toothed blades.

These Tungsten Carbide Grit edge HoleSaws are available in the following sizes:

16mm, 19mm (3/4"), 20mm, 22mm (7/8"), 25mm (1"), 29mm (1 1/8"), 32mm (1 1/4"), 35mm(1 3/8"), 38mm (1 1/2"), 44mm (1 3/4"), 48mm (1 7/8"), 51mm (2"), 54mm (2 1/8"), 57mm (2 1/4"), 60mm (2 3/8"), 64mm (2 1/2"), 70mm (2 3/4"), 76mm (3"), 83mm (3 1/4"), 86mm (3 3/8"), 95mm (3 3/4"), 102mm (4"), 114mm (4 1/2")

The Hole saws up to 30mm fit any standard ½” thread A1 Mandrel and Hole Saws from 32mm to 152mm fit any standard 5/8” thread A2 Arbors / Mandrels but we recommend using a Mandrel with a TCT Pilot for Masonry or one of our Special Spear point Tile Drill Pilot Mandrels for cutting Ceramic Tile.

After All What’s the point having a Hole Saw that can cut through Brick and Tile if the Pilot Drill Can't?

Who uses our Hole Saws?

Professionals DIY and Remodellers, Tile Installers, Construction Workers, Engineers, Plumbers, Electricians, Air Conditioning Engineers, Kitchen Fitters, Masons, Composite Manufacturers and users such as Fiberglass Boat Builders and Auto Body Kit Manufacturers, Component testers, Aerospace Industry, Graphite Industry,Insulation manufacturers, Woodworking..

Home